国产疯狂女同互磨高潮在线看

<menuitem id="zbj9p"></menuitem>
<listing id="zbj9p"><thead id="zbj9p"><meter id="zbj9p"></meter></thead></listing>

    <listing id="zbj9p"><span id="zbj9p"></span></listing>

      <big id="zbj9p"></big>

          <listing id="zbj9p"><track id="zbj9p"><ol id="zbj9p"></ol></track></listing>

            返回

            AW39104FOR

            AW39104 is a 4-bit high-performance voltage-level translator without direction control signal, which is a non-inverting converter and can be used to convert digital signal with mixed-voltage systems. It needs two separate power supply rails, with the A ports tracks the VCCA ranging from 1.65 V to 3.6 V, and the B ports tracks the VCCB ranging from 2.3 V to 5.5 V. This makes the chip has capabilities of support both lower and higher logic signal levels translation between any of the 1.8 V, 2.5 V, 3.3 V, and 5 V voltage nodes.

            If the voltage level of output-enable (OE) pin is low, the chip works in the high-impedance state, which costs ultra-low power-supply quiescent current. And the OE input circuit is supplied by VCCA. Meanwhile, OE is recommended to be tied to GND through a pull-down resistor to ensure the highimpedance state during power up or power down. No power supply sequencing requirements means either VCCA or VCCB can be powered up first, and OE should be enabled after both VCCA and VCCB are established.

            產品特性

            l    Voltage Level Translator Without DirectionControl Signal

            l    Maximum Data Rates 

                - 24Mbps (Push Pull) 

                - 2Mbps (Open Drain) 

            l    Power Supply Range: 

                - A Port and VCCA: 1.65 V to 3.6 V 

                - B Port and VCCB: 2.3 V to 5.5 V 

                - VCCA ≤ VCCB 

            l    Pull Up Resistors are Integrated in A Port and B Port 

            l    No Power-Supply Sequencing Required: Either VCCA or VCCB Can be Ramped First 

            l    Support Ultra-Low Power Consumption Mode with OE Pin is Low Voltage Level 

            l    I/O Pin ESD: - A Port: 2.5 kV (HBM) - B Port: 6 kV (HBM) 

            l    Latch -Up Performance Exceeds ±200mA Under JESD 78 Standard 

            l    FOR 1.87mm×1.37mm-12B Package

            Datasheet

            Application note

            產品型號 文檔格式 大小 下載
            AW39104FOR PDF
            • Maximum Data Rate(Mbps)
              VCCA Range(V)
              VCCB Range(V)
              Channel
              Support
              Package (mm)
            • AW39104FOR

              24
              1.65-3.6
              2.3-5.5
              4
              Open Drain Push-Pull
              FOWLP 1.87×1.37-12B
            封裝形式 引腳數 長(mm) 寬(mm) 厚(mm) 引腳間距(mm) 散熱盤 文檔下載
            隱私政策 | 使用條款

            ? Copyright 2008-2021 上海艾為電子技術股份有限公司 |   滬ICP備10011954號??Powered by IT

            国产疯狂女同互磨高潮在线看
            <menuitem id="zbj9p"></menuitem>
            <listing id="zbj9p"><thead id="zbj9p"><meter id="zbj9p"></meter></thead></listing>

              <listing id="zbj9p"><span id="zbj9p"></span></listing>

                <big id="zbj9p"></big>

                    <listing id="zbj9p"><track id="zbj9p"><ol id="zbj9p"></ol></track></listing>